4 August 2013
Bottom Bracket
Fixed cup too tight. Cannot remove it. Lots of WD40, but it wont budge.
Derallieur
 |
Removed the 2 brass bolts that fix the derailleur (hanger) to the bike frame;
|
 |
And then removed the 1 brass bolt that fixes it to the bottom of the leaver (below the pivot)
|
 |
Here it is, ready for cleaning. Note; all bolts face outwards. The solid bar moves the mechanism (to change gears), the spring maintains tension of the wheel.
|
 |
outside of rear derailleur |
 |
inside of rear derailleur |
 |
Spring attachment to bar |
 |
removed the derailleur lever |
 |
Took apart the bottom jockey wheel. The very bottom section of the cage is on the outside of the assembly
|
 |
Cleaned up jockey wheel. going to need to figure out how to lubricate the bearings in this.
|
 |
Now its time to dissasemble the top section of the derailleur.
|
 |
The linkage between the spring and the derallieur is a bent spoke (spoke more obvious in photo after this one). I started trying to open this, but quickly decided just to leave it attached.
|
 |
It took a while to undo one of the 2 bolts holding the cage to the wheel; there is a screw slot that I needed to turn while holding the bolt, the slot was not very deep and was difficult to turn, I may have damaged the slot and should try to replace it.
|
No comments:
Post a Comment